This page no longer updated from 31 October 2001. Latest version can be found at www.astronautix.com

astronautix.com Aeronutronics Project 7969

Project 7969 Designs
Project 7969 Designs
Project 7969 ballistic designs. From left: Lockheed; Martin; Aeronutronics; Goodyear; McDonnell; Convair

Credit: (c) Mark Wade. 6,524 bytes. 640 x 110 pixels.


Class: Manned. Type: Spacecraft. Nation: USA. Agency: USAF. Manufacturer: Aeronutronics.

Aeronutronics's proposal for the Air Force initial manned space project was a cone-shaped vehicle 2.1 m in diameter with a spherical tip of 30 cm radius. The man within was enclosed in a gimballed sphere and rotated to line the pilot up with accelerations. The vehicle would be launched by any one of several two-stage vehicles, including the USAF baseline Atlas Hustler. Deorbit would be accomplished by a retrorocket. The spacecraft was automatic and no pilot control functions were needed. The heat shield used graphite shingles. In case of booster failure during ascent to orbit the capsule would be ejected. The spacecraft had a ballistic coefficient (W/CdA) of 300 kg per square meter. Landing precision was within a 160 x 80 km footprint. It was expected that a first manned orbital flight could be only be achieved six years after go-ahead.


Specification

Total Length: 2.1 m. Maximum Diameter: 2.1 m. Total Mass: 1,150 kg.



Bibliography:



Back to Index
Last update 12 March 2001.
Contact Mark Wade with any corrections or comments.
Conditions for use of drawings, pictures, or other materials from this site..
© Mark Wade, 2001 .